January 31, 2008, 08:42 PM | #1 |
Junior Member
Join Date: November 10, 2005
Posts: 7
|
Ishapore 308 vs SMLE
Will a bolt from an SMLE #1 mk3 fit an ishapore 308 and work if I change to a 308 extractor? Thanks!
|
January 31, 2008, 10:06 PM | #2 |
Member In Memoriam
Join Date: March 17, 1999
Posts: 24,383
|
With the usual caveats about headspace and the possible need for some fitting, the answer is yes.
One thing, though. All reports are that the 2A rifle was made with better steel than the SMLE, and that would apply to the bolt as well as the receiver, so you should keep a close check on headspace if you make a swap like that, as the lugs might batter more than they would with the right bolt. I also advise not using commercial .308 ammo in that rifle; stick to 7.62 NATO specs. Jim |
January 31, 2008, 11:03 PM | #3 |
Senior Member
Join Date: December 16, 2004
Location: Grand Forks, ND
Posts: 5,333
|
Chances are that you can get it to fit. However the steel in the bolt will not be up to the 2a standards.
__________________
I don't carry a gun to go looking for trouble, I carry a gun in case trouble finds me. |
February 1, 2008, 05:04 AM | #4 |
Junior Member
Join Date: November 10, 2005
Posts: 7
|
ishapore
I wondered about the bolt, although the bolt body is listed as the same number in gunparts, as the #1mk3. I knew the rec. was different, just didn't know if the bolt was better steel or not.
|
|
|