|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Search | Today's Posts | Mark Forums Read |
|
Thread Tools | Search this Thread |
June 2, 2013, 03:20 PM | #1 |
Senior Member
Join Date: March 12, 2009
Location: Greybull, Wyoming
Posts: 416
|
Savage Model 7 (JC Higgins 101.16) Extractor Removal
Hey fellas,
I am working on my dads old 22 due to failure to extract spent cases. The extractor hook is boogered up pretty good so I looked for parts and found them available. I removed the left side extractor by pulling the plunger down and levering the extractor out of its pocket. (I used a pointy brass cleaning jag) The right side is kicking my arse though. I can't seem to get any purchase on the top edge of the plunger to begin pulling it down. Anyone have experience with this operation? Thanks in advance for your help!
__________________
Brad
|
June 2, 2013, 04:27 PM | #2 |
Senior Member
Join Date: March 12, 2009
Location: Greybull, Wyoming
Posts: 416
|
Got it!
OK - I got it out. The tension on the plunger was noticeably different than the LH side and it appears that a spring other than factory had been installed at some point. I think this caused the difficult extraction.
Thanks!
__________________
Brad
|
Thread Tools | Search this Thread |
|
|