|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Search | Today's Posts | Mark Forums Read |
|
Thread Tools | Search this Thread |
December 24, 2012, 09:16 PM | #1 |
Junior Member
Join Date: December 22, 2012
Posts: 3
|
model 70 Winchester 7mm short mag failure to eject
Two different times now ive had failure to eject final
Round from mag.its just stuck n the barrel. Round fired fine. Any ideas fellas? |
December 25, 2012, 12:57 AM | #2 |
Staff
Join Date: November 2, 1998
Location: Colorado
Posts: 21,823
|
Extracted round is OK suggests to me there's no excessive expansion of the cartridge and that chamber pressure is OK.
Clean the extractor and beneath the extractor. If that doesn't work, you might have to change the extractor spring (insufficient pressure to cause extractor to hold onto the case while it is being withdrawn).
__________________
Vigilantibus et non dormientibus jura subveniunt. Molon Labe! |
December 25, 2012, 07:23 PM | #3 |
Senior Member
Join Date: July 15, 2012
Location: Wonderful, Windy Wyoming
Posts: 133
|
And maybe check that the extractor is sharp.
|
Thread Tools | Search this Thread |
|
|