The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > The Dave McCracken Memorial Shotgun Forum

Reply
 
Thread Tools Search this Thread
Old June 25, 2012, 08:08 PM   #1
TheKlawMan
Junior member
 
Join Date: June 23, 2009
Location: Orange County, CA
Posts: 2,149
Reasonable Rate of Bad Primers

What is a reaonable rate of primer failures? My reloads with Win209 primers seem to fail about once every 1,500 shots. These are with good pin strikes.
TheKlawMan is offline  
Old June 25, 2012, 11:27 PM   #2
olddrum1
Senior Member
 
Join Date: March 23, 2008
Location: Mid Missouri
Posts: 807
Never
olddrum1 is offline  
Old June 25, 2012, 11:36 PM   #3
zippy13
Senior Member
 
Join Date: August 23, 2008
Location: SoCal
Posts: 6,442
TKM, like my friend, olddrum, I've never had a failure to fire that I've attributed to a bad primer.
FYI: I load WW primers in WW cases.
zippy13 is offline  
Old June 26, 2012, 01:55 AM   #4
TheKlawMan
Junior member
 
Join Date: June 23, 2009
Location: Orange County, CA
Posts: 2,149
Zippy, our friend. This was a win209 primer in a WW hull (the silver one). We disected it at the range and it was well packed with powder. The pin left a pretty good indentation in it.
TheKlawMan is offline  
Old June 26, 2012, 08:45 AM   #5
zippy13
Senior Member
 
Join Date: August 23, 2008
Location: SoCal
Posts: 6,442
My friend, since you're relatively new to reloading, here's something to think about: Are you sure the primer wasn't double struck? On very rare occasions, I've somehow got a spent primer mixed in with the new ones. I've always noticed it while loading; but, if overlooked, the FTF might be considered due to a bad primer.
zippy13 is offline  
Old June 26, 2012, 12:29 PM   #6
TheKlawMan
Junior member
 
Join Date: June 23, 2009
Location: Orange County, CA
Posts: 2,149
No, Zippy. It was a shiny new primer out of a sleeve of 5,000. The hull was in great shape, the primer was seated nicely, and the powder was well packed. The recipe was 18 grains of Promo, an alsost new silver AAHS hull, 1-1/8 ounces of shot, and a WAA12 wad (the CB Clone). My powder drops with the bushing I used are falling right on that 18 grains mark +/_ .15 grains. I was shooting with Weatherby at the time and we cut into the hull to verify that it was packed with powder.
TheKlawMan is offline  
Old June 26, 2012, 01:02 PM   #7
zippy13
Senior Member
 
Join Date: August 23, 2008
Location: SoCal
Posts: 6,442
Were the primers possibly adulterated -- might they have been hit by the over-spray from a gun cleaning product?
zippy13 is offline  
Old June 26, 2012, 01:20 PM   #8
oneounceload
Junior member
 
Join Date: April 18, 2008
Location: N. Central Florida
Posts: 8,518
At the rate they make those things, if 1 out of 1500 so far, maybe the entire sleeve of 5000, that isn't too bad

Did you try it in the other barrel? I say this because Brownings are notorious for light (but good looking) primer strikes, especially in the bottom barrel
oneounceload is offline  
Old June 26, 2012, 01:26 PM   #9
BigJimP
Senior Member
 
Join Date: February 23, 2005
Posts: 13,195
I had a few Win 209 primer failures ....about 4 or 5 yrs ago .... I had half a dozen out of 500 shells or so ....and then it went away / and no issues since.

At the time I had some issues with the Win 209's -- I fired them up in practice / but never had another issue .../ and for awhile I shifted to Remington primers and Chedite....

I think its kind of like anything else ...issues like this come and go .../ when you buy the next batch of primers, it'll probably go away.
BigJimP is offline  
Old June 26, 2012, 02:06 PM   #10
TheKlawMan
Junior member
 
Join Date: June 23, 2009
Location: Orange County, CA
Posts: 2,149
Oneounce. I didn't try it in the upper barrel becasue I wanted to see if it appered to be a bad poweder drop, but it was the lower barrel. The first two were from the same 100 primer box and that was over 2,000 shells back. Of those two one went bang in the top barrel but the other was just a dud. The one last week was out of the first 100 box of the fourth 1,000 of the same sleeve. The primer strike looked pretty good.
TheKlawMan is offline  
Old June 26, 2012, 02:10 PM   #11
TheKlawMan
Junior member
 
Join Date: June 23, 2009
Location: Orange County, CA
Posts: 2,149
Jim. You are probably right. 1 in a thousand isn't the end of the world if all you shoot is practice. 5 or 6 out of 500 would be a huge deal, I imagine, if you were in competition.
TheKlawMan is offline  
Old June 26, 2012, 06:02 PM   #12
TheKlawMan
Junior member
 
Join Date: June 23, 2009
Location: Orange County, CA
Posts: 2,149
I found that I kept the FTF and cut deeper so I could view the primer from the inside. It fired but the powder didn't. Zippy may be right and somehow a fired primer got reused.
TheKlawMan is offline  
Old June 26, 2012, 06:07 PM   #13
BigJimP
Senior Member
 
Join Date: February 23, 2005
Posts: 13,195
1 in 5,000 would be too many ....if I was shooting my reloads in competition.../ you don't need that kind of stuff creeping into your mental game.

I'd have to check the current rules carefully ...but if a shell misfires, its considered "defective ammo" - providing there is a noticeable firing pin dent in the primer....but you're only allowed 2 defective shells out of the first box ( or 25 targets ) ....after 2 defective rounds...the shooter is allowed to replace the box of ammo with a new box of factory ammo ( and you get 2 more defective shells ) ...but if the shooter elects not to replace the ammo after the first 2 defective shells ...then any misfires after that are lost targets.

I'm not sure how the current rule reads in registered 5 Stand or sporting Clays shoots...

gun malfunctions - get a little more complicated...( but the rules cover gun malfunctions --- as well as ammo malfunctions ).
BigJimP is offline  
Old June 26, 2012, 06:10 PM   #14
oneounceload
Junior member
 
Join Date: April 18, 2008
Location: N. Central Florida
Posts: 8,518
In 5-stand or sporting after 2 malfs, thew next is a lost target
oneounceload is offline  
Old June 26, 2012, 06:19 PM   #15
zippy13
Senior Member
 
Join Date: August 23, 2008
Location: SoCal
Posts: 6,442
Quote:
In 5-stand or sporting after 2 malfs, thew next is a lost target
It's the same in NSSA Skeet and ATA trap -- the third failure to fire, in a single event (typically 100 targets), is scored as a lost target.
zippy13 is offline  
Old June 27, 2012, 01:27 AM   #16
olddrum1
Senior Member
 
Join Date: March 23, 2008
Location: Mid Missouri
Posts: 807
There are two or three reasons to have a ftf other than poor quallity of a primer. Shot in the primer seating pocket can move the anvil. Picking up damp hulls and throwing them in a plastic bag. What Z said about spraying your primer tray. Getting spent primers mixed with good primers *I don't think this is to likely but not impossible for the very talented."
Now my story.
Several years ago the club I shot at had a corporate event. Closed for the afternoon, cook out, shoot all you want, you get the picture. Close to dark Rain set in and shut the shooting down. Two of my good friends were the first through the next day and it was as if it had rained once fired AA's. The owner let them pick up the emptys. Sun was out and they looked dry. I got to shoot the first round with them and the new hulls they had scored. The drop out rate was. by my quess. 20 to 25 out of fifty. The hulls were still wet inside. For what its worth.
olddrum1 is offline  
Old June 27, 2012, 01:49 AM   #17
340 Weatherby
Senior Member
 
Join Date: March 25, 2012
Posts: 139
Klawman, just do what I do. Borrow (steal) 300 Weatherby's ammo.
340 Weatherby is offline  
Old June 27, 2012, 02:39 AM   #18
TheKlawMan
Junior member
 
Join Date: June 23, 2009
Location: Orange County, CA
Posts: 2,149
I didn't know this was X rated

Quote:
Were the primers possibly adulterated
It is very unlilkely that the primer or primers were sprayed with any gun cleaning product or anything similar. It is possible but very unlikely that the hull was damp inside. The anvil also appears to be located about right. I think this is operator error and I am "talented".
TheKlawMan is offline  
Old June 27, 2012, 06:16 AM   #19
Mike Irwin
Staff
 
Join Date: April 13, 2000
Location: Northern Virginia
Posts: 41,374
I don't recall ever having a primer failure with a shotshell load, and at one time my Dad and I were going through 20,000 or so rounds a year.
__________________
"The gift which I am sending you is called a dog, and is in fact the most precious and valuable possession of mankind" -Theodorus Gaza

Baby Jesus cries when the fat redneck doesn't have military-grade firepower.
Mike Irwin is offline  
Old June 27, 2012, 10:00 AM   #20
TheKlawMan
Junior member
 
Join Date: June 23, 2009
Location: Orange County, CA
Posts: 2,149
Stealing 300 Weatherby's ammo I like!
TheKlawMan is offline  
Old June 27, 2012, 01:51 PM   #21
Dave McC
Staff In Memoriam
 
Join Date: October 13, 1999
Location: Columbia, Md, USA
Posts: 8,811
Last year I had two duds in the same batch of primers,Win 209s. I shipped them back to Winchester, who couldn't find anything wrong.

Those are the only two I can recall, out of close to 100K primers.
Dave McC is offline  
Old June 27, 2012, 03:50 PM   #22
l98ster
Senior Member
 
Join Date: March 1, 2010
Location: Hopewell Junction, NY
Posts: 454
I must have reloaded close to 50,000 rounds using Winchester 209's. I cannot recall a single "dud".

-George
l98ster is offline  
Old June 27, 2012, 11:09 PM   #23
.300 Weatherby Mag
Senior Member
 
Join Date: September 6, 2008
Posts: 1,777
I've had a factory winchester AA refuse to light a gun that has seen many thousands of flawless rounds since.. The bad ones are out there...
.300 Weatherby Mag is offline  
Old August 6, 2012, 09:28 PM   #24
TheKlawMan
Junior member
 
Join Date: June 23, 2009
Location: Orange County, CA
Posts: 2,149
I finally called Winchester about the primers. A nice lady gave me another number to call for for the ammunition company and then I got passed from one person to someone else's voicemail. Needless to say no one has called back and I don't think I should hold my breath for a call back. The one at Winchester said it was very difficult to reach someone at the ammunition company (I think she meant Olin).
TheKlawMan is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:14 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.10405 seconds with 10 queries