February 7, 2013, 06:48 PM | #1 |
Senior Member
Join Date: May 5, 2010
Location: Santa Fe, NM
Posts: 474
|
Portable target stand
made this this afternoon, base is 18x36, middle section is also 18x36, and top is 18x24, all 3/4" plywood, cut to 3" wide and joined with pocket screws. some smaller pieces cut to 4" long for the brackets on the base and between the top and middle sections. still need to add cardboard to top section. no tools needed to put together or take apart, should fit in most any trunk.
|
February 7, 2013, 09:47 PM | #2 |
Senior Member
Join Date: December 5, 2007
Location: Virginia
Posts: 1,041
|
I made one out of pvc. I got the idea off of youtube. It took me about 5 mins. to make.
|
February 8, 2013, 01:23 PM | #3 |
Senior Member
Join Date: January 27, 2013
Posts: 116
|
Nice stand
|
February 8, 2013, 03:22 PM | #4 |
Senior Member
Join Date: November 7, 2008
Posts: 151
|
Thanks for posting that. I normally use campaign signs but I've run out and really need to make something up.
Sent from my ADR6425LVW using Tapatalk 2 |
February 8, 2013, 04:02 PM | #5 |
Member
Join Date: February 4, 2013
Location: Georgia
Posts: 42
|
Well done!
I also use those campaign signs a lot, i keep shooting through the wires though, i may to need rethink where i tape up the target sheets |
Thread Tools | Search this Thread |
|
|