Marlin 22lr not ejecting

Olibobwa · March 16, 2010, 08:26 PM

The bolt is grabbing the case but not spitting it out. I have to pull it loose to chamber another round. Any ideas??

Goldy · March 18, 2010, 09:34 PM

I got an idea. Why not try giving the model number and a little better description of your problem.

Lots of folks would be glad to help but we have to know what gun you have.

Please go into a little more detail..

Olibobwa · March 18, 2010, 10:35 PM

I can do that. It's a model 25. It's a bolt action rile. My problem is that after discharging a round and opening the bolt the spent cartridge remains attached to the front of the bolt instead of being ejecting out of the hole where the brass is supposed to pop out. It remains held in place by two small clamps. I have to pull each round out manually.

From what I can tell the inner clamp must move enough to release the case and the pressure from the outer clamp pops it out.

Scorch · March 19, 2010, 01:59 AM

Your ejector is broken. Midway has them.
http://www.midwayusa.com/viewProduct...tNumber=457627

Pahoo · March 19, 2010, 10:35 AM

Quote:

Your ejector is broken. Midway has them.

This too would be my call as I had this happen to me except, on a model-60. You should be able to observe the ejector's action by slowly operating the bolt. The ejector tip will come into view at or close to the rear travel of the bolt. It contacts at the base of the rim and pushes it out of the port. Again, you should be able to see it happen.

Be Safe !!!

waterfowler · March 19, 2010, 02:15 PM

I would say the ejector

March 16, 2010, 08:26 PM	#1
Olibobwa Member Join Date: November 24, 2007 Posts: 82	Marlin 22lr not ejecting The bolt is grabbing the case but not spitting it out. I have to pull it loose to chamber another round. Any ideas??

March 19, 2010, 01:59 AM	#4
Scorch Senior Member Join Date: February 13, 2006 Location: Washington state Posts: 15,248	Your ejector is broken. Midway has them. http://www.midwayusa.com/viewProduct...tNumber=457627 __________________ Never try to educate someone who resists knowledge at all costs. But what do I know? Summit Arms Services

March 19, 2010, 02:15 PM	#6
waterfowler Senior Member Join Date: January 31, 2010 Posts: 115	I would say the ejector __________________ If guns are outlawed, only the outlaws will have guns

March 18, 2010, 09:34 PM	#2
Goldy Senior Member Join Date: May 23, 2004 Posts: 163	I got an idea. Why not try giving the model number and a little better description of your problem. Lots of folks would be glad to help but we have to know what gun you have. Please go into a little more detail..

March 18, 2010, 10:35 PM	#3
Olibobwa Member Join Date: November 24, 2007 Posts: 82	I can do that. It's a model 25. It's a bolt action rile. My problem is that after discharging a round and opening the bolt the spent cartridge remains attached to the front of the bolt instead of being ejecting out of the hole where the brass is supposed to pop out. It remains held in place by two small clamps. I have to pull each round out manually. From what I can tell the inner clamp must move enough to release the case and the pressure from the outer clamp pops it out.