November 9, 2004, 03:20 AM | #1 |
Junior Member
Join Date: November 9, 2004
Posts: 2
|
Cabela Hawken
I just bought a Cabela's Sporterized Hawken.
Found it in the bargain cave at a price I couldn't pass up. It was missong the rear sight and whatever it is that holds the ram rod in place. The rear sight I took care of(another bargain cave special). All I need now is the ram rod part. Looking at the schematic I can't see what this model uses to hold the rod in place. Took the barrel off and still can't figure it out. Antbody have an idea what I need? And where I can get it? Thanks! Jokey |
November 17, 2004, 12:40 AM | #2 |
Senior Member
Join Date: September 19, 2004
Location: Nebraska
Posts: 302
|
do you mean the thimbles? I just looked at my cabelas traditional and there does not appear to be a special "thingy" to hold the rod in place. It appears the tunnel it fits into just narrows slightly in the middle to hold it snug. I dont know where to get a thimble. cabelas should be able to help though. E
|
November 26, 2004, 12:49 PM | #3 |
Junior Member
Join Date: November 9, 2004
Posts: 2
|
Nope,both thimbles are there.
Looked at a Sporterized Hawken like mine on the shelf the other day. Just behind the bottom thimble on the underbarrel rib there is a small screw holding a piece of spring steel. That steel is what was holding the rod on that rifle. Went home home and looked at mine and nothing...not even a hole in the rib. Might be why it was in the bargain cave to begin with. Nice wide thick rubber band seems to be working well so far! |
|
|