March 20, 2013, 08:36 PM | #1 |
Senior Member
Join Date: April 4, 2012
Location: South Jersey
Posts: 2,217
|
the 9mm's
I just bought (i cant pick up until permits come in, PR of NJ) a PA63 that fires that trendy 9mm Mak. I now have the standard 9mm Luger (1911) a 9mm Largo (1911ish) and now a 9mm Mak (PA63). What components are cross compatible?
On a side note I have all the stuff for 460 and the pizza guy gave me 100 or so cases today.
__________________
Concentrated power is not rendered harmless by the good intentions of those who create it. Milton Freidman "If you find yourself in a fair fight,,, Your tactics suck"- Unknown |
March 21, 2013, 01:45 PM | #2 |
Senior Member
Join Date: November 16, 2010
Location: Arkansas
Posts: 996
|
9x18,9x19 and 9x21. Way to tough for my old eyes. Have fun and don't mix and match your brass.
__________________
NRA life member When the going gets tough, I just open another beer. |
March 30, 2013, 09:37 AM | #3 |
Member
Join Date: November 27, 2012
Posts: 23
|
I have both Luger and Mak, cross compatible between them....
Primer, Power and Shellholder. then you can add a unversal de-primer and ammo box... Seriously be carefull about mixing up your Brass....take a Mak shell and run it through your luger resizer and notice the feel...that way "WHEN" one gets mixed in you will double check it. I have done several and had no effect on the shell. Flare, load and it pressure fits back out to normal. A Luger shell in the Mak die has almost NO resistance at all when resizing in a Luger die. |
|
|