|
July 19, 2023, 10:40 AM
|
#1 |
|
Junior Member
Join Date: July 9, 2023
Posts: 4
|
Henry. 357/38
Hi
I need recommendations for a ladder sight for my Henry 357/38. Any? Is difficult to install it? Thanks Eric |
|
|
July 19, 2023, 03:33 PM
|
#2 |
|
Senior Member
Join Date: March 18, 2009
Location: Temple, TX
Posts: 959
|
The only source I know of, for a ladder sight is "Skinner Sights" (skinnersights.com). The installation should be easy, but it could be more complicated if you also need a higher front sight. I would suggest going to the skinner website for installation instructions and front sight compatibility.
I'm assuming that you mean an actual ladder sight and not folding tang peep sights. If you're thinking about tang sights instead, then you're probably limited to Lyman or Marbles. Skinner and Ranger Point Precision also make receiver sights for the henry big boy. I think the Skinner sight is the better sight, but I installed the Ranger Point receiver sight on my henry big boy .357, because it was compatible with the height of the existing front sight. Last edited by hammie; July 19, 2023 at 03:40 PM. |
|
|
|
July 20, 2023, 07:20 AM
|
#3 |
|
Junior Member
Join Date: July 9, 2023
Posts: 4
|
Oh, ok. I’ll check!
Thanks! |
|
|
|
July 20, 2023, 03:56 PM
|
#4 |
|
Staff
Join Date: November 2, 1998
Location: Colorado
Posts: 21,845
|
I like the Skinner Ladder Sight. I have something like that on a 22.
__________________
Vigilantibus et non dormientibus jura subveniunt. Molon Labe! |
|
|
|
July 20, 2023, 04:08 PM
|
#5 |
|
Junior Member
Join Date: July 9, 2023
Posts: 4
|
Ok, I think I’ll try!
|
|
|
 |
|
|
