September 19, 2004, 12:26 AM | #1 |
Senior Member
Join Date: September 19, 2004
Location: Nebraska
Posts: 302
|
38-55
I am new to lever guns, but have found two wich appeal to me. The first is the Marlin 1895CB in 45-70, The second is the 336CB in 38-55. The trouble is I am having alot of trouble finding info on the latter, or someone who can tell me about firsthand knowledge of it. Any help would be appreciated.
Big Ruger |
September 25, 2004, 03:06 AM | #2 |
Senior Member
Join Date: July 9, 2004
Location: Oklahoma by birth. America by the grace of God.
Posts: 635
|
The .38-55, like the .38-40 WCF pistol/rifle round, is a .40 caliber - not a .38. It is based on the straight-walled .30-30 case. It is not as powerful as the .45-70 and is useful for deer-sized game at close range. If hunting is what you want the rifle for - the .45-70 would be best. If you want it for something like Cowboy Action Shooting - the .38-55 might be a better choice.
BTW - Ammo for the .38-55 will be a bit harder to find and you will have fewer load choices (unless you handload) than for the .45-70.
__________________
Quando Omni Flunkus Moritati (If all else fails - play dead!) Support the Second Amendment. Join the NRA > http://www.nra.org < Oklahoma State & Big 12 - #1 GO POKES!!!!! |
September 26, 2004, 12:11 AM | #3 |
Senior Member
Join Date: September 19, 2004
Location: Nebraska
Posts: 302
|
Thanks Boomer, I handload so ammo's no prob. I saw both rifles on marlins site and the 45-70 at Cabelas. I want em both. But maybe for my first lever gun I should go with the one that is better all around. I have always shot and loaded modern high power rounds so I want a new challenge. Is the 45-70 hard on meat? I have heard both ways but wondered if ammo choice might have some bearing. Thanks again.
|
September 26, 2004, 03:07 AM | #4 |
Senior Member
Join Date: July 9, 2004
Location: Oklahoma by birth. America by the grace of God.
Posts: 635
|
BR,
Ammo selection will have a BIG effect on the .45-70. If you load it like a "poor man's" .458 Win Mag you're going to lose LOTS of meat! Loaded to "standard" velocities (like the old 405-gr factory loading) with hard-cast bullets that have large, flat noses or appropriate soft/hollow point bullets you can, as Elmer Keith liked to say, eat right up to the hole. Enjoy!
__________________
Quando Omni Flunkus Moritati (If all else fails - play dead!) Support the Second Amendment. Join the NRA > http://www.nra.org < Oklahoma State & Big 12 - #1 GO POKES!!!!! |
September 26, 2004, 11:47 AM | #5 |
Senior Member
Join Date: October 25, 2001
Location: Alabama
Posts: 18,532
|
The .38-55 is NOT a .40 caliber like .38-40.
It IS a true .38 caliber. My Winchester Single Shot is .378" and I cast a bullet just slightly over that diameter for it. Current Marlins run .380" or .381" groove diameter. From what I have read on the SASS Wire, gunsmiths and the Marlin shop are doing a brisk business opening up the chambers which are to official but incorrect specification to clear a .376" bullet. There has been a lot of wild shooting with .38-55s based on the Lyman handloading manual's listing of .375" for bullets. Barrels that small are scarce to nonexistent except maybe for modern rifles made up with H&H barrel blanks. |
September 29, 2004, 04:12 PM | #6 |
Junior Member
Join Date: September 1, 2004
Posts: 8
|
The 30-30 is based on the 38-55 rather than vice versa. The 38-55 in a Marlin action is an AWESOME deer or black bear cartridge.
|
September 30, 2004, 12:41 PM | #7 |
Senior Member
Join Date: June 14, 2004
Location: NY State
Posts: 6,575
|
There was an early high velocity load of 255gr @ 1700 which certainly would work on deer and bear. ..
|
Thread Tools | Search this Thread |
|
|