|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Today's Posts | Search |
|
Thread Tools | Search this Thread |
December 14, 2011, 07:59 PM | #1 |
Member
Join Date: December 14, 2011
Posts: 15
|
norinco hawk 982 sights
the norinco hawk model 982 12 gauge has a set of ghost ring sights and i was wondering what is the best way to remove the front sight and add a bead to the front of the gun? i liked the ghost ring sight at first but now i just want to get a bead sight, also what brand of bead sight should i get? "thanks"
|
December 14, 2011, 09:54 PM | #2 |
Member
Join Date: December 13, 2011
Location: Kentucky
Posts: 20
|
Try spraying some PB blaster on it and letting it sit for 25 minutes and then try sliding or pulling it off with channellocks.
__________________
"Take care of your weapon, and your weapon will take care of you." |
December 15, 2011, 03:52 PM | #3 |
Member
Join Date: December 14, 2011
Posts: 15
|
i think you can heat it up with a blow torch and knock it off with a rubber mallet. and then glue back on a bead sight, then refinish
|
December 15, 2011, 04:36 PM | #4 |
Senior Member
Join Date: March 11, 2009
Location: Atlanta, GA
Posts: 247
|
^^^
This. Be careful not to hit the barrel with the mallet. Using a 2 part epoxy on the bead means you can put your old front sight back on if you want to. |
December 15, 2011, 07:50 PM | #5 |
Senior Member
Join Date: September 7, 2004
Location: SE NC
Posts: 1,239
|
Sell the 982 to someone who wants GR sights, and buy yourself a Pardner pump. Last I looked, there were no NIB 982s (or 981s, same gun with bead sight) available anywhere...
__________________
Mindset - Skillset - Toolset. In that order! Attitude and skill will get you through times of no gear, better than gear will get you through times of no attitude and no skill. |
|
|