hi point 9mm carbine sling stud

Dangerwing · July 30, 2012, 04:33 PM

Im looking for some technical advise. I recently bought a used Hi Point model 995 9mm carbine. It shoots surprisingly well and over all I'm very happy with it. There is one glitch though - the rear sling stud is mounted on the right side of the stock. This would be great if I was left handed, but I'm not. I disassembled the stock (splits in half along the length of the stock), but I can't figure out how to removed the threaded nut that is in the stock so I can move it to the other side. Is it just press fit in there? Is it removeable? Any help would be appreciated.

Thanks

July 30, 2012, 04:33 PM	#1
Dangerwing Senior Member Join Date: April 9, 2007 Location: South Dakota Posts: 237	hi point 9mm carbine sling stud Im looking for some technical advise. I recently bought a used Hi Point model 995 9mm carbine. It shoots surprisingly well and over all I'm very happy with it. There is one glitch though - the rear sling stud is mounted on the right side of the stock. This would be great if I was left handed, but I'm not. I disassembled the stock (splits in half along the length of the stock), but I can't figure out how to removed the threaded nut that is in the stock so I can move it to the other side. Is it just press fit in there? Is it removeable? Any help would be appreciated. Thanks __________________ Alcohol Tobacco and Firearms should be an aisle at Wal-Mart, not a government agency! Only faithful men teach their wives to shoot.