|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Search | Today's Posts | Mark Forums Read |
|
Thread Tools | Search this Thread |
January 13, 2012, 07:02 PM | #1 |
Member
Join Date: February 20, 2009
Location: MN
Posts: 26
|
Mounting red dot on Ruger mkIII 22/45
I have had the rail mounted on this ruger before and when i removed it (old red dot bit the dust) the rail left two very fine lines on the top of barrell,is there any thing i could put between the two surfaces to keep this from happening. The marks are from the edge of the acc rail. Thanks,and yes i did have the screws blue locktited.
|
January 15, 2012, 04:39 PM | #2 |
Member
Join Date: August 17, 2008
Location: S.E. TN.
Posts: 45
|
I removed a "DOT" from my MK111 (stainless) the base was the one that came with the gun. There were some minor marks from the scope base, I used MOTHERS Mag & Aluminum polish to remove the marks. If yours is a blue gun maybe some blue touch-up and follow with FLITZ polish. I usually use some 600/800 grit sandpapper to clean the edges on the base, befor I mount it, to limit as much scoring as possible. I havn`t seen any type of "sheild" sold for a scope base, but i guess you could fashion one.
|
Thread Tools | Search this Thread |
|
|