The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools Search this Thread
Old July 5, 2013, 11:13 PM   #26
MEATSAW
Senior Member
 
Join Date: May 1, 2009
Location: Burnet, TX
Posts: 727
In my experience the Rem 7 1/2 primers were cream-of-the-crop from my AR15. They've also been exceptional in my 45 ACP. Might be something else going on here.
__________________
Veteran OEF (2002) and OIF1 (2003) - US Army
Member of the Burnet Gun Fighters, Inc. and of course the NRA
Oregon State University alum -- Go Beavs!
MEATSAW is offline  
Old July 5, 2013, 11:54 PM   #27
medalguy
Senior Member
 
Join Date: August 31, 2009
Location: New Mexico
Posts: 1,033
Same here. All I use in .223 is 7-1/2 Remington, or Tula if I run short of Remington. Over the past 45 years I have probably loaded at least 250,000 Remington primers, and I can't say that I ever had a bad one.

I agree, check the case setup. Might be excessive setback. And try the ammo in another .30-06 rifle too.
medalguy is offline  
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:25 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.03252 seconds with 8 queries