The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools Search this Thread
Old October 10, 2011, 05:49 PM   #1
p5200
Senior Member
 
Join Date: April 1, 2008
Posts: 241
starter punch to loosen the M&P 40 FS Extractor pin

I've read elsewhere, that one of the sets of three tapered nail sets using the 1/32" size would work to get the pin moving. Then it was said the 1/16" straight punch which I have could be used to tap it the rest of the way out the nail set I will have to purchase though. Can any of you smiths familiar with this job, verify it's doable using a nail set for a starter punch? Or can you please, recommend a Starter punch that will work without breaking and where to purchase one? Thanks!
p5200 is offline  
Old October 11, 2011, 06:01 PM   #2
p5200
Senior Member
 
Join Date: April 1, 2008
Posts: 241
Problem solved, I got pin out.
p5200 is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:41 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.04737 seconds with 10 queries