|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Today's Posts | Search |
|
Thread Tools | Search this Thread |
January 15, 2009, 01:47 PM | #1 |
Junior member
Join Date: October 13, 2008
Location: Houston
Posts: 64
|
RCBS Trim Pro not lining up
I just got a new RCBS Trim Pro case trimmer and the case seems to be lining up at the 7 oclock position with the cutter. I bought a 3 waycutter, so I checked the cutter against the standard cutter supplied with the trim pro and they are both finding the case mouth at the case's 7 oclock position.
The instructions say to press down on the handle and let the pilot find the mouth that way. Is my trimmer out of alignment? I don think I want to trim with pressure at any angles to the case - shouldnt it go right into the mouth without pressure? |
January 15, 2009, 02:26 PM | #2 |
Junior member
Join Date: October 13, 2008
Location: Houston
Posts: 64
|
Ok, so I called RCBS, and described the issue.
Apparently, they send you a new cutter shaft when you have any front to back misalignment. They gave it right up, so they must be having an issue with these cutter shafts they just produced. I tried for an RCBS hat for my trouble but no luck. Problem "solved". |
|
|