The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools Search this Thread
Old November 13, 2007, 07:24 AM   #1
Bosshoff
Senior Member
 
Join Date: May 20, 2004
Posts: 173
Where can I get small screw for scope ring?

I have a no-name set of Weaver 1.0" bases. One of the allen screws which clamps the scope tube is semi-stripped. I went to my local Ace Hardware, and could not match up the threads. I am going from memory here, so I may be off, I think the screw was a #6, but the tread count was fine? Where can I get replacements? (I hate to order a single screw from Brownells, the rings only cost me $10.00.)
__________________
Chop Chop!
Bosshoff is offline  
Old November 13, 2007, 10:37 AM   #2
Slopemeno
Senior Member
 
Join Date: January 19, 2007
Posts: 2,663
It's 6-48, and you won't find it a your local Ace hardware. Try the local gunsmith, or a well equipped gun shop, or order some from Brownells.
Slopemeno is offline  
Old November 14, 2007, 05:06 PM   #3
George R
Senior Member
 
Join Date: December 17, 2004
Location: Boca Raton, FL
Posts: 151
6-48

If you can use a 1/4" 6-48, pm me your postal address and I'll send you one.
George R is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:16 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.04208 seconds with 10 queries