January 23, 2005, 08:17 AM | #1 |
Member
Join Date: December 15, 2004
Posts: 22
|
Torque specs
What is the tightening sequence and torque specs for the action screws on a Rem 700 ADL?
Thanks. |
January 28, 2005, 10:59 AM | #2 |
Junior Member
Join Date: May 8, 2002
Location: Washington
Posts: 4
|
From what I have seen, the norm is 40 to 60 inch pounds.
|
January 28, 2005, 01:46 PM | #3 |
Senior Member
Join Date: October 12, 1999
Location: Arkansas USA
Posts: 436
|
but torque is stock dependent
a wood stock can be as low as 20 in. pounds.... pillar, fiberglass/composit, lam, etc., can range up to 65 in. Lbs. Best bet, get the product number and e-mail the MFG. Slightly off subject but I remember when with the old 3 screw Winchester you could actually warp the action with the middle screw.... so it is best to ask. |
|
|