May 17, 2012, 08:56 PM | #1 |
Junior member
Join Date: February 10, 2009
Posts: 974
|
Barrel liners
here is my questio, who is actually making them these days? the few i can find online are all for converting your weapon into a 22 or .17
|
May 18, 2012, 11:00 AM | #2 |
Senior Member
Join Date: February 13, 2006
Location: Washington state
Posts: 15,248
|
What are you trying to do? To reline a barrel to centerfire, there are a few people who do it. You can call John Taylor at Taylor Machine 253-445-4073. Cost is about the same as rebarreling, but many people who want the original markings left intact prefer to reline a barrel rather than rebarrel and lose the original markings.
__________________
Never try to educate someone who resists knowledge at all costs. But what do I know? Summit Arms Services |
May 18, 2012, 09:01 PM | #3 |
Junior member
Join Date: February 10, 2009
Posts: 974
|
well im thinking of a centerfire to center fire conversion. so far the only handgun barrels i can find are pencil barrels for smith and colt revolvers circa 1950-1960, and a few liners that turn your gun into a rim fire.
|
May 19, 2012, 08:30 PM | #4 |
Member In Memoriam
Join Date: March 17, 1999
Posts: 24,383
|
The tubes usually called "liners" are thin and cannot be used with high pressure cartridges. The reason is that when reaming out the original barrel enough space must be left for the solder or whatever is used to keep the liner in place. That means the liner is smaller than the barrel, so it must be able, itself, to contain the pressure, otherwise the liner will expand in an irregular manner depending on the irregularities of the solder or epoxy.
When it is desired to "line" the barrel for use with high pressure ammunition, a standard lightweight barrel is machined down so it will fit into the original barrel. Unless the original barrel was quite thick, it becomes a thin shell. But the inner barrel (some call it an "insert", reserving the term "liner" for the low pressure kind) must be thick enough to hold the pressure. Not many gunsmiths will do that work and they usually do it with many caveats and cautions. That kind of "insert" is usually used where the rifle is a collectors item and it is desired to keep the original barrel markings. Jim |
|
|