March 31, 2011, 10:54 AM | #1 |
Senior Member
Join Date: August 9, 2009
Posts: 645
|
Adjusting pull on M9
The factory trigger of roughly 5.5-6lbs on the M9 is a bit more than where it should be IMO. Is there a way to adjust it down to 4-5bls without buying a new trigger assembly? What are my options?
|
March 31, 2011, 10:58 AM | #2 |
Senior Member
Join Date: February 20, 2011
Location: M'burg WV
Posts: 332
|
I would think a good gunsmith could tune your trigger/sear for you, but if a factory pack is offered that can reduce it, it may be about the same price. Plus you can retain a "factory" trigger pull, as opposed to a modified one.
__________________
Busting thugs since 1992 |
March 31, 2011, 01:47 PM | #3 |
Senior Member
Join Date: June 19, 2010
Posts: 2,145
|
There is a simple $5 fix for exactly that. Swap out the FS mainspring for the factory "D" mainspring used in the 92/96 DAO pistols (part number C99001). It will drop the DA pull from 11-12 to 8-9 pounds and the SA pull to what you're asking for. I ordered my springs from Dave Olhasso's site. You can probably find them at Beretta USA's or Brownells' websites.
|
Thread Tools | Search this Thread |
|
|