The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old December 7, 2009, 07:46 PM   #1
Skofnung
Member
 
Join Date: April 29, 2002
Location: Atlanta Area
Posts: 49
Revolver Refinish Using Aluma Hyde Question

Hey Y'all.

I am planning on refinishing a badly worn Rossi revolver using Aluma Hyde II. What I would like to know is, what is the consensus on dis-assembly? Should I break it all the way down and mask the interior surfaces, or should I only remove the cylinder/yoke assembly and spray over the side-plate screws?

I am concerned that if I leave the side-plate on, the paint will make the removal of the side-plate difficult down the road, as well as look bad.

What think you? Experiences?

Thanks.
Skofnung is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:29 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05171 seconds with 9 queries