The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools Search this Thread
Old September 30, 2001, 08:00 PM   #1
44Special
Member
 
Join Date: October 14, 1999
Location: Gallitzin,Pa. USA
Posts: 27
Installed Timney Trigger on Savage Scout

I finally got around to replacing the factory trigger on my Savage Scout with a new Timney Featherweight.

The replacement was quite easy. Just remove the "e-clip" on the center pin then take out the old trigger and put in the new. The Timney has a coil trigger weight spring as opposed to the piano wire spring that the original had.

The instructions that came with the Timney were very good, and I now have a nice, crisp 2.5 lb. trigger in my Savage Scout.
44Special is offline  
Old October 1, 2001, 11:31 PM   #2
Art Eatman
Staff in Memoriam
 
Join Date: November 13, 1998
Location: Terlingua, TX; Thomasville, GA
Posts: 24,798
Good replacement for that junky tort-liability POS in a Ruger 77 Mk II, also.

, Art
Art Eatman is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:31 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.05038 seconds with 10 queries