Romy AK 47 build

daytooday · April 22, 2010, 09:30 PM

I just pressed in a new barrel into a romy kit. I purchased a go and no go gauge. Using the gauges the bolt closes on both of them. I didn't buy the field gauge because they didn't have one in stock. Where do I go from here. DO I need the field gauge? Is there another alternative?

Thanks

Old Guard Dog · April 23, 2010, 01:36 PM

If it is a new barrel, the barrel pin was not drilled yet, so you can press until the NO-GO won't close. I never had to, but I have heard of pressing for proper headspace and drilling an oversize pin in. I would try to get the proper spacing. I think there are some FIELD gauges available for 7.62x39, but you should not mix brands of gauges.

daytooday · April 23, 2010, 03:45 PM

It is a new barrel so I don't have to worry about a previous pin hole. I had though pressed the barrel in as far as possible or so I think. I pulled it out some and have now pressed it back in so I will now check again.

Thanks for your help

April 22, 2010, 09:30 PM	#1
daytooday Junior Member Join Date: April 14, 2010 Posts: 11	Romy AK 47 build I just pressed in a new barrel into a romy kit. I purchased a go and no go gauge. Using the gauges the bolt closes on both of them. I didn't buy the field gauge because they didn't have one in stock. Where do I go from here. DO I need the field gauge? Is there another alternative? Thanks

April 23, 2010, 03:45 PM	#3
daytooday Junior Member Join Date: April 14, 2010 Posts: 11	Thanks It is a new barrel so I don't have to worry about a previous pin hole. I had though pressed the barrel in as far as possible or so I think. I pulled it out some and have now pressed it back in so I will now check again. Thanks for your help

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

April 23, 2010, 01:36 PM	#2
Old Guard Dog Senior Member Join Date: December 23, 2008 Location: SE PA Posts: 101	If it is a new barrel, the barrel pin was not drilled yet, so you can press until the NO-GO won't close. I never had to, but I have heard of pressing for proper headspace and drilling an oversize pin in. I would try to get the proper spacing. I think there are some FIELD gauges available for 7.62x39, but you should not mix brands of gauges.