|
March 28, 2002, 01:10 AM
|
#1 |
|
Senior Member
Join Date: November 5, 2001
Posts: 111
|
Hammer Spring on P95DC
I would like to improve the DA pull on my Ruger P95DC and though that replacing the hammer spring might do the trick. Looks relatively easy to do, in fact I have already completely disassembled the gun twice. Do I replace the hammer spring or could I cut off a couple of coils? Is there anything I need to be aware of after doing this?
It would be nice to improve the SA pull but I am aware that this is best left to a gunsmith. |
|
|
March 28, 2002, 07:56 AM
|
#2 |
|
Staff Alumnus
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
|
Go to www.gunsprings.com and see what Wolff has to offer in a lighter hammer spring. If you do decide to start clipping coils I recommend that you go ahead and buy a spare hammer spring in case you go too far. George
|
|
|
 |
|
|
