The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools Search this Thread
Old May 1, 2007, 05:00 AM   #1
Wasper
Member
 
Join Date: July 13, 2006
Posts: 56
Czech VZ52 Barrel Removal?

I have an old VZ-52 rifle with a rusted out bore. I want to install a spare barrel that I have. I've removed the barrel retaining pin.

How should I proceed from here? I think the barrel is press fit. I was thinking of using a large brass bar and heavy hammer to break it loose but the rear end of the receiver gets in the way. Seems like it would also be a problem if trying to use some type of barrel press.

Any suggestions?

Thanks!
Wasper is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:56 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.02703 seconds with 10 queries