September 28, 2007, 04:00 PM | #1 |
Junior Member
Join Date: September 18, 2007
Posts: 14
|
Primer Questions
Can I use the same small primer for a 9mm, 40cal, 45ACP and .233?
I have read information about bullets and powder but nothing about primers and cannot figure it out! |
September 28, 2007, 04:47 PM | #2 |
Senior Member
Join Date: June 4, 2006
Location: West Virginia
Posts: 2,258
|
No. 9mm and 40 will be a small pistol primer. 45 will be a large pistol primer. 223 will be a small rifle primer. The reloading manual should tell you what primer was used in their test.
Rusty
__________________
I don't ever remember being absent minded. |
September 28, 2007, 05:22 PM | #3 |
Senior Member
Join Date: September 8, 2007
Location: Mississippi
Posts: 16,190
|
Don't try to use small rifle or large rifle primers in small or large pistol calibers. Even tho they're the same diameter the length of rifle primers is longer.
|
September 29, 2007, 07:18 PM | #4 |
Senior Member
Join Date: June 4, 2006
Location: West Virginia
Posts: 2,258
|
In my Speer manual it calls for small rifle magnum primers with W748 and H335 powders. I have used standard SRP and not had any problems.
Rusty
__________________
I don't ever remember being absent minded. |
September 30, 2007, 04:48 PM | #5 |
Senior Member
Join Date: May 13, 2006
Location: WA, the left armpit of the USA
Posts: 1,323
|
There has been so much nonsense written about primers, even in supposedly sagacious publications, that some years ago, in addition to asking a great many annoying questions of every major primer maker, I had to do my own primer experiments.
Hodgon and Winchester (which at the time were different companies) both disparaged the idea that magnum primers needed to be used in non-magnum loads when using their ball (Win) or spherical (Hod) powders. My tests, such as they were, agreed. As to primer dimensions: The two predominate sizes of primers in use today fall into the basic categories of “small” and “large.” These may be further defined as being either rifle or pistol primers. Differences between the two include priming composition mixture, cup thickness and sensitivity, and very slight dimensional discrepancies in height. Within these sub-categories, the primers are defined still further, as standard, magnum, and in rifles, benchrest primers. Distinctions between these types vary from brand to brand, but most relate to composition mixtures, intensity and quality control standards during production. Diameters of the two sizes are .175" for the small rifle and pistol, and .210" for the large rifle and pistol, respectively. * * From "Exterior Ballistics" a part of the very informative Sierra handloading manual. You should never use pistol primers in a rifle cartridge, as the cup is softer and may be blanked (pierced) when struck by the firing pin. If you must substitute a rifle primer in a handgun cartridge don't be surprised if it does not ignite properly or fail to ignite, especially in handguns that use a transfer bar to strike the primer instead of a direct blow from the hammer.
__________________
"If the enemy is in range, so are you." - Infantry Journal |
|
|