|
November 11, 2001, 05:30 PM
|
#1 |
|
Senior Member
Join Date: June 13, 2001
Location: Caracas
Posts: 137
|
Extractor Pin.
Hi everyone:
I am trying to remove the extractor from my SW 6906 but the pin seems to be very, very tight. I struck it a couple of times with a punch and since it didn´t come out I stopped trying in fear that I may break or mushroom the pin. No damage done but I need to replace the extractor. Do you have any usefull advice for me on this tight pin?? Any input would be highly welcomed. Thank you very much. 
__________________
- Stay safe - |
|
|
November 12, 2001, 09:08 AM
|
#2 |
|
Staff Alumnus
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
|
Hellequin, this pin is under pressure from the extractor spring. It may take a little extra umph to get it out. Make sure you have the correct drift for this. I always try to remove these type pins from the inside of the slide to avoid possibly scratching it. George
|
|
|
|
November 12, 2001, 11:58 AM
|
#3 |
|
Senior Member
Join Date: June 13, 2001
Location: Caracas
Posts: 137
|
Dear George:
Which tools (drift, punches, etc) would you recommend to make this job in a good, fast, trouble free way?? Thanks. 
__________________
- Stay safe - |
|
|
 |
| Thread Tools | |
|
|
