The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old August 23, 2001, 07:09 PM   #1
Ray HP
Member
 
Join Date: July 7, 2000
Posts: 56
Help with Powder Selection

I am new to reloading and would appreciate some help selecting a good powder for 223 and 30-06. I was thinking of using the reclaimed military powder because it is cheap. With my limited knowledge, it appears that WC-844 is a good choice for 223 and IMR 4895 is a good choice for 30-06.

I took an educated guess that WC-844 is better than WC-846 for 223.

The reloads will be used for high power service rifle competition, 200, 300, 600yd.

Thanks in advance for all coments and suggestions.
Ray HP is offline  
Old August 23, 2001, 08:10 PM   #2
MADISON
Senior Member
 
Join Date: January 1, 2000
Location: Roanoke, Virginia
Posts: 2,678
223 and 30-06 powder selection

I load my 223 and 30-06 with Winchester 748. I get less than 1/2 inch groups at 100 yards.
MADISON is offline  
Old August 24, 2001, 02:16 PM   #3
Poodleshooter
Senior Member
 
Join Date: August 7, 2000
Location: Floating down the James River in VA
Posts: 2,539
Yup, that's a pretty good selection. I'd really pick Varget as the best powder for both. I'm currently shooting WCC846 in .223; it's not bad, but takes a grain or 2 more to get the same velocity as 844. Unfortunately, like every ball powder, it sucks when temperature or humidity vary a lot.
Poodleshooter is offline  
Old August 24, 2001, 02:34 PM   #4
Bob243
Member
 
Join Date: December 2, 2000
Posts: 54
I am using VHT N-135 for my 223, with 53g sierra HPFB and getting consistant less than .150" groups @ 100 yards with my 700VS ( when I do my part )
Bob243 is offline  
Old August 24, 2001, 03:30 PM   #5
Bogie
Senior Member
 
Join Date: June 5, 2000
Location: Job hunting on the road...
Posts: 3,827
For surplus powder, I'd use 4895 - I shoot it with 55 grainers in my .223, and it does just fine in a .308 - shouldn't be that far off in the .30-06...
__________________
Job hunting, but helping a friend out at www.vikingmachineusa.com - and learning the finer aspects of becoming a precision machinist.

And making the world's greatest bottle openers!
Bogie is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:32 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06459 seconds with 9 queries