The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old July 13, 2001, 06:43 PM   #1
KYE-OAT
Senior Member
 
Join Date: July 6, 2001
Location: AR
Posts: 121
Mosin Nagant Bolt Handles

Are the Scope-mounting kits with the new bolt handle difficult to install?
Also why can't the original handle be forged between two blocks like Mausers are???
KYE-OAT is offline  
Old July 14, 2001, 07:40 AM   #2
George Stringer
Staff Alumnus
 
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
Kye-0at, they are not difficult but you want to make sure the hole in the root is dead center. It's basically just cutting off the old handle, drilling and tapping the root for the new handle. I've never attempted to forge a Mosin handle. They're short as is and if you forged one you probably wouldn't have a handle much over an inch long after the bend. A new handle could be welded on but I think forging is out of the question for these. George
George Stringer is offline  
Old July 18, 2001, 12:22 AM   #3
Clark
Senior Member
 
Join Date: December 4, 1999
Location: WA, the ever blue state
Posts: 2,811
I have been taking them to Lynwood Guns and ammo for TIG welding. If I do nothing, it is $25, and if all he does is weld, it is $5.

The Moisin Nagant is a remarkable gun [but ugly].
Clark is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:18 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05400 seconds with 9 queries