The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old January 29, 2014, 10:55 PM   #1
A pause for the COZ
Senior Member
 
Join Date: October 11, 2012
Location: Braham, Minnesota
Posts: 341
45 acp Mauser conversion.

I have a Rhineland arms conversion kit coming. Finally going to get started on this.
Had to take the Barreled action to a Gunsmith to remove the old barrel
That sucker was on there.

Ok simple question for you guys in the know.

I need a extended 1911 mag release for this kit.
Any one know were I might find these. I can find the individual parts from various sources. But I assume I need the lock, spring and the release?
Do they sell these as a kit?
A pause for the COZ is offline  
Old January 29, 2014, 11:18 PM   #2
littlephil
Member
 
Join Date: January 28, 2014
Location: Coshocton, Ohio
Posts: 48
I'm not sure if they have any kind of kits, but I would try brownells.com if you haven't already. I know that they have an extensive line of products just for 1911s. I imagine that you have probably already thought of that, but I figured it wouldn't hurt to mention it and try to help. Hopefully someone can help you out a little more but I thought I'd try. Good luck and I hope you can put up some pics of it when its finished, or better yet of the process.
littlephil is offline  
Old January 29, 2014, 11:30 PM   #3
A pause for the COZ
Senior Member
 
Join Date: October 11, 2012
Location: Braham, Minnesota
Posts: 341
Sure will.

Right now I have just looked through the Midway catalog and Ebay.
Have to check the other places from home. They block all the good stuff from work.
Some how the Firing line snuck through the blockers.
Shhhhhh I was not here...

I am going to let my Gun smith do some of the work.
Remove the barrel
Bend the bolt.
Install the scope mount.

I am going to do the rest. My buddy has volunteered to do the Duracoating.
I am good with that. I hate that stuff.
A pause for the COZ is offline  
Old January 30, 2014, 11:53 AM   #4
littlephil
Member
 
Join Date: January 28, 2014
Location: Coshocton, Ohio
Posts: 48
Don't worry, I didn't see anything. A look at my brownells book shows that you can get an extended mag release kit for $29.99 blued or $34.99 stainless. It says that it comes with the spring and lock. Part number is 4E26V47 for blued and 4E28V27 for stainless. You've probably already found what you're looking for but I hope this helps.
littlephil is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:10 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06638 seconds with 9 queries