The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old April 15, 2013, 07:54 PM   #1
Beginner 1960
Member
 
Join Date: March 11, 2012
Location: East TN
Posts: 46
H-6 crimp?

Just loaded some lite 44 loads 240gr. lswc's with 7 grs. of H-6 with a lite crimp, looks like I have quite a bit of unburnt powder.
Was wondering if I need a heavyer crimp or up my powder charge, this is my 1st time loading with this powder.

Or do I need to use a faster burning powder for my lite loads?
Beginner 1960 is offline  
Old April 15, 2013, 08:18 PM   #2
57K
Junior member
 
Join Date: March 2, 2013
Location: Heart of Texas
Posts: 788
HS-6 is fine for that use but I would use load data from your manual vs. data from the Hodgdon website. You need a good roll crimp as well as a magnum primer because HS-6 is a fairly dense spherical where just about any load manual will recommend a magnum primer, even for the lighter loads. You might get by with a Win. WLP primer, but your best bet would be to use a magnum primer.
57K is offline  
Old April 15, 2013, 08:38 PM   #3
Beginner 1960
Member
 
Join Date: March 11, 2012
Location: East TN
Posts: 46
Thanks,thats good starting to run a little short on lp primers but have plenty of mag primers.
Beginner 1960 is offline  
Old April 16, 2013, 07:51 AM   #4
WESHOOT2
Senior Member
 
Join Date: February 20, 1999
Location: home on the range; Vermont (Caspian country)
Posts: 14,139
firmer

I firmly crimp virtually all my 'revolver' ammo (I actually vary crimp and test).
__________________
.
"all my ammo is mostly retired factory ammo"
WESHOOT2 is offline  
Old April 16, 2013, 01:51 PM   #5
Hammerhead
Senior Member
 
Join Date: May 31, 2004
Location: Minnesota
Posts: 1,559
More crimp, magnum primers for HS-6 in revolvers.
You don't need a faster powder, but faster powders will burn more completely and keep your gun cleaner.
Hammerhead is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:06 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06534 seconds with 9 queries