The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools
Old February 16, 2013, 06:48 PM   #1
Senior Member
Join Date: August 30, 2010
Posts: 1,269
FC 10 or FC 10 Match reload problems?

So I've run across some brass that looks to be .45 ACP, but it is headstamped as either FC 10 or FC 10 MATCH.

I am having a hard time seating primers in them, as there is a step leading into the primer pocket instead of a nice radius/chamfer as found on most brass.

So far I've weeded out about 20 of them out of my pile of brass.

Any thoughts on this brass?

maillemaker is offline  
Old February 16, 2013, 09:37 PM   #2
Senior Member
Join Date: June 6, 1999
Location: El Paso, TX
Posts: 1,011
I've seen this stuff too. Those are crimped primer pockets and you'll need to remove them if you want to reload the cases. I personally just throw them out.
New gun, same ol' shot.
Adamantium is offline  

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 07:59 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2015 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.04381 seconds with 9 queries