The Firing Line Forums

Go Back   The Firing Line Forums > Hogan's Alley > Handguns: The Revolver Forum

Thread Tools Search this Thread
Old February 3, 2013, 02:00 AM   #26
Senior Member
Join Date: January 9, 2013
Posts: 278
If you're worried about the barrel/cyl. gap, fire it while holding a sheet of white paper about a foot away from the gun on each side & see what it does to the paper. A few small specs are usually normal, but I'd be worried about any holes that you can see light through. If it's very much excessive people on either side of you at the range should notice.
oldgunsmith is offline  
Old February 5, 2013, 12:03 AM   #27
Join Date: January 23, 2013
Location: Northern Arizona
Posts: 15
Thanks for that suggestion, OldGunSmith. I'll try it next time I shoot.
TonyAZ is offline  

cylinder gap , s&w 19

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 06:22 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2015 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.13862 seconds with 10 queries