The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old January 9, 2013, 08:55 PM   #1
Jimro
Senior Member
 
Join Date: October 18, 2006
Posts: 5,281
Installing AR Front Sight block on a drilled barrel.

I bought a used DCM legal Krieger barrel second hand, and the previous owner did not include a gas block.

I tried Sporter Express in Elizabethtown,KY, but the armorer their said that he couldn't do anything, and so now I'm thinking about the steps needed to fit a front sight block to a drilled and tapered barrel and still maintain a DCM legal appearance.

I wish I had a milling machine, because that would make this job a piece of cake. Unfortunately I don't, I have a drill press and normal set of hand tools.

Here is what I have so far.

First, measure the tapered holes in the barrel to see if they are parallel and record the dimension from the shoulder of the HBAR profile.

Second, index the new FSB onto the barrel and mark both using permanent marker.

Third, while the the FSB is indexed, use a marking awl to put a divot on the larger side.

Fourth, remove the FSB from the barrel, and drill into the side for the larger taper for both pins. This hole will be larger than the taper pin.

Fifth, put the FSB back on the barrel, indexed to our mark.

Sixth, drill through the FSB, use the taper reamer to cut the taper just a hair more, install taper pins. The thin end will mechanically lock the FSB in place.

Seventh, use a filling agent around the larger head of the pins for cosmetic uniformity. The filling agent can be pretty permanent since this is going to be a competition rifle, and the next time the FSB comes off it will be because the barrel is shot out (a few seasons down the road to be sure).

Are there any gunsmiths or machinists who see any problems with this plan?

Jimro
__________________
"Gorsh" said Goofy as secondary explosions racked the beaten zone, "Did I do that?"

http://randomthoughtsandguns.blogspot.com/
Jimro is offline  
Old January 10, 2013, 01:33 AM   #2
wyop
Senior Member
 
Join Date: July 15, 2012
Location: Wonderful, Windy Wyoming
Posts: 133
Well, you'll likely find that unless you use a center drill, using a twist drill will wander off your mark in a hurry.

You'll need to slow the drill press way down to use a reamer, and you'll need to flood it with cutting oil or other lube.

Doing these kinds of jobs on floppy machines usually begets poor results.
wyop is offline  
Old January 11, 2013, 09:32 AM   #3
triggerman770
Senior Member
 
Join Date: August 9, 2009
Location: Metro Atlanta Area
Posts: 124
gas block

Have you tried Kreiger? most gas blocks should fit it, as they are available in many diameters
__________________
Small Arms Restoration, Inc.
" I started with nothing and Still have most of it left thanx to the federal gov't"
triggerman770 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:27 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2013 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05873 seconds with 9 queries