The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > The Dave McCracken Memorial Shotgun Forum

Reply
 
Thread Tools
Old December 7, 2012, 09:21 PM   #1
breakingcontact
Junior member
 
Join Date: October 25, 2012
Location: Austin, TX
Posts: 736
how to bend shotgun magazine spring?

I am installing a new spring in a shotgun.

How do I bend the ends of the spring so they lay flat?
breakingcontact is offline  
Old December 8, 2012, 09:28 AM   #2
hogdogs
Staff In Memoriam
 
Join Date: October 31, 2007
Location: Western Florida panhandle
Posts: 11,071
I turn the end tips into center of diameter then with 2 pairs of needle nose, I hold with one and tweak the tip into the spring a bit...

But I do not think you need to worry unless the ends are askew...

With the way the spring fits in the shell follower, it sould settle in fine...

I AM NO SMITH SO THIS ADVICE IS WORTH WHAT YOU PAID FOR IT!!!

Brent
hogdogs is offline  
Old December 8, 2012, 11:34 AM   #3
PetahW
Senior Member
 
Join Date: September 19, 2008
Posts: 4,679
The ends don't need to be "bent flat" - just drop the spring down into the mag tube against the inside of the cupped follower, compress the forward/free end into the tube & install the end cap.


.
PetahW is offline  
Old December 8, 2012, 12:18 PM   #4
BillM
Senior Member
 
Join Date: January 20, 2009
Location: Amity Oregon
Posts: 342
Agreed---you don't need to mess with it.


If you ever DO need to get the last turn on a spring
to lay flat--say a cut down recoil spring or something--

Heat a flat piece of steel to red, press the end of the spring
against it. that last coil will heat and bend flat without
screwing up the temper of the rest of the spring.
BillM is offline  
Old December 8, 2012, 12:20 PM   #5
hogdogs
Staff In Memoriam
 
Join Date: October 31, 2007
Location: Western Florida panhandle
Posts: 11,071
Thanks for the more proper way to do this... I will try to remember it next time a spring needs such...

I reckon for a light wire spring like a mag tube spring, you could just do this on a conventional electric range burner on high?

Brent
hogdogs is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:45 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05977 seconds with 9 queries