The Firing Line Forums

Go Back   The Firing Line Forums > Hogan's Alley > Handguns: The Semi-automatic Forum

Reply
 
Thread Tools
Old November 15, 2012, 12:35 PM   #26
Taptap
Member
 
Join Date: April 8, 2008
Location: Seattle
Posts: 99
I think you should move on, cause unless you know that the safety isn't going to continue wearing on the frame, any re-finishing will be a short lived fix. The reality is: this is a fairly common level of "wear" for a lot of pistols, of many makes and models. Thumb safeties quite often end up rubbing a bit.
If you worry too much about leaving room in the fitment of the safety, instead of worrying about getting a nice and tight fit, you'd end up with more sloppy safeties and a few less rub marks.

I don't think it's something to worry about, or spend money fixing. It's just not worth it.

But hey, check out my perfect finish!


Just kidding. Just like almost every other pistol in the world, I have a couple spots where the finish is worn. CZ's in particular may not even have the finish completed on the inside of the pistol. Mine is that way.

Last edited by Taptap; November 15, 2012 at 12:41 PM.
Taptap is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:29 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05067 seconds with 9 queries