The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old November 14, 2012, 10:30 PM   #1
chris in va
Senior Member
 
Join Date: December 26, 2004
Location: Louisville KY
Posts: 12,493
SP01 owners, a question

Could you measure your factory rubber grips? I'd like to find out if they would fit my 97b, even with a slight gap toward the front.
chris in va is offline  
Old November 15, 2012, 11:37 AM   #2
cogito
Member
 
Join Date: October 16, 2012
Location: Mid-Western State
Posts: 37
Can you tell me what precisely you want measured? Length, top width, middle, bottom, etc?

They're not a regular polygon, so a few measurements would be needed.
cogito is offline  
Old November 16, 2012, 01:14 AM   #3
chris in va
Senior Member
 
Join Date: December 26, 2004
Location: Louisville KY
Posts: 12,493
Mainly width and length. I think it might (sorta) fit on my 97b, just wondering how much gap I'll have to accept.

I fitted the factory plastic 75b grip on it and there was some 'daylight' showing from inside the frame toward the front strap.

Basically just trying to find grips with the 'coke bottle' profile. CZ in their infinite wisdom decided to make the grips flat on the 97.

Last edited by chris in va; November 16, 2012 at 01:24 AM.
chris in va is offline  
Old November 16, 2012, 09:50 PM   #4
cogito
Member
 
Join Date: October 16, 2012
Location: Mid-Western State
Posts: 37
Width across bevel at the top: 1"
Width across top flare: 1 3/8"
Width at screw: 1 1/2"
Width at CZ log: 1 1/2"
Width at very bottom: 1 3/8"

Length across mid-line of grip: 3 3/4"

Of course, I may be off a bit here and there, but the above should be within 1/8th of an inch, probably more like a 1/16 margin of error.

(SP-01, standard/base model)
cogito is offline  
Old November 30, 2012, 12:21 AM   #5
chris in va
Senior Member
 
Join Date: December 26, 2004
Location: Louisville KY
Posts: 12,493
Thank you very much!
chris in va is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:24 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06230 seconds with 9 queries