The Firing Line Forums

Go Back   The Firing Line Forums > The North Corral > Curios and Relics

Reply
 
Thread Tools
Old October 2, 2012, 04:44 PM   #1
donbjazzbones
Junior Member
 
Join Date: October 2, 2012
Posts: 13
carcano identification? help?

bought this carcano (1938?) a while back im trying to see exactly what one it is and trying to confirm it shoots 6.5x55 before i go out and buy ammo... I did use the search before posting just incase there was some info but i couldnt find anything
also the barrel to the back of the bolt measures roughly 25 inches




donbjazzbones is offline  
Old October 2, 2012, 04:51 PM   #2
donbjazzbones
Junior Member
 
Join Date: October 2, 2012
Posts: 13
....

6.5x52 ****
donbjazzbones is offline  
Old October 2, 2012, 04:58 PM   #3
BillM
Senior Member
 
Join Date: January 20, 2009
Location: Amity Oregon
Posts: 346
Welcome to the forum.

Yes, it's a Carcano

NO it does NOT use 6.5x55. That would be for a Swedish Mauser.

Assuming it is still in the original chambering, it takes 6.5 x 52 Carcano
ammo. It also uses a CLIP---a device which holds the ammo.

It will fire without the clip, but it will be a single shot, not a repeater.

Several manufacturers load 6.5 Carcano, not sure if there is any cheap
mil-surp in that caliber. Been a long time since I had a Carcano.
Someone will be along shortly with the particulars of model etc.
BillM is offline  
Old October 2, 2012, 05:01 PM   #4
carguychris
Senior Member
 
Join Date: October 20, 2007
Location: Richardson, TX
Posts: 5,501
The correct designation is 6.5x52. 6.5x55 is the cartridge used in Swedish Mauser rifles and is not compatible.

The "CAL 6,5" marking indicates that the rifle is chambered in 6.5x52. The other WWII Italian cartridge was the 7.35x51, and these rifles carry a chamber marking of "CAL 7,35".

I do not own a Carcano, but IIRC you must use the proper en bloc clip to fire the rifle as a repeater; it will only work as a single-shot without a clip in the magazine. That said, Carcano clips are readily available on the 'Net, and even at some well-stocked local shops that specialize in military surplus.

That rifle appears to have an M1 Carbine front barrel band grafted onto it! I've seen some interesting garage workshop projects on old milsurp rifles, but that's something I've never seen!

[EDIT] It appears that BillM types faster than me.
__________________
"Smokey, this is not 'Nam. This is bowling. There are rules... MARK IT ZERO!!" - Walter Sobchak
carguychris is offline  
Old October 2, 2012, 05:08 PM   #5
donbjazzbones
Junior Member
 
Join Date: October 2, 2012
Posts: 13
ya i was a little off when i couldnt find a carcano that had the m1 style front barrel band so i couldnt figure out what it was or what year lol it took me about a day of google to find out that it was a carcano thanks for the help so far and as for the clip i did get one with it.
donbjazzbones is offline  
Old October 2, 2012, 05:09 PM   #6
carguychris
Senior Member
 
Join Date: October 20, 2007
Location: Richardson, TX
Posts: 5,501
Oh yeah, I'll share one tip about Carcanos that I learned when I was checking out a used one...

Do NOT disassemble the cartridge elevator assembly! The spring is supposedly very difficult to reinstall properly without a special tool that was presumably available to Italian Army armorers until 1943 but has been very hard to find since then.

If the elevator does not smartly spring back up after being pushed down, the spring is mangled or missing... and the rifle will most likely only function as a single-shot.
__________________
"Smokey, this is not 'Nam. This is bowling. There are rules... MARK IT ZERO!!" - Walter Sobchak
carguychris is offline  
Old October 2, 2012, 05:13 PM   #7
donbjazzbones
Junior Member
 
Join Date: October 2, 2012
Posts: 13
thanks for tip.... elevator is working correctly so who whoever the last owner was hopefully didnt take it apart lol
donbjazzbones is offline  
Old October 2, 2012, 05:42 PM   #8
donbjazzbones
Junior Member
 
Join Date: October 2, 2012
Posts: 13
on another note,

anyone ever deer hunted with one?
donbjazzbones is offline  
Old October 2, 2012, 05:44 PM   #9
tahunua001
Senior Member
 
Join Date: July 21, 2011
Location: Idaho
Posts: 6,142
the rounds have quite a bit of wind drift and bullet drop IIRC so they aren't great over range but I bet it would make one heck of a brush gun.
__________________
ignore my complete lack of capitalization. I still have no problem correcting your grammar.
I never said half the crap people said I did-Albert Einstein
You can't believe everything you read on the internet-Benjamin Franklin
Bean counters told me I couldn't fire a man for being in a wheelchair, did it anyway. Ramps are expensive.-Cave Johnson.
tahunua001 is offline  
Old October 2, 2012, 05:54 PM   #10
donbjazzbones
Junior Member
 
Join Date: October 2, 2012
Posts: 13
well im taking it to the range thursday or friday and going to see if it even works lol but then its going to be my all around rifle this years hunt! lol i like a challenge i guess lol
donbjazzbones is offline  
Old October 2, 2012, 06:21 PM   #11
rightside
Senior Member
 
Join Date: February 4, 2012
Location: Oklahoma
Posts: 105
True 6.5 carcano uses a .268 bullet. Most of the 6.5 carcano ammo you find new is .264 in diameter. That's because all the 6.5's these days use that bullet, so it's cheaper to manufacture them all with the same dia. bullet. Hornady is the only one I know that sell a true .268 Carcano load and its available through http://www.grafs.com/retail/catalog/...productId/6888 exclusively. The other stuff ,Prvi partizan, etc; load the .264. It works , but don't expect the accuracy that a true 6.5 (.268) 160 gr. Carcano load will give you.(I can't get less than 3-4" at 100 yds with the .264 dia. loads) If you handload, Graf has the correct bullets also. You can buy the dies from them with a .268 expander, too. The .264 dia.bullet has contributed to tales of the Carcano's inaccuracy. They also have a gain twist barrel, so if someone cut the barrel down, you'll loose accuracy . Yours appears to have been altered a fair amount(stock cut down, top wood handguard missing, M1 carbine front stock retainer, some kind of strange front site/ muzzle device?) Your barrel length(minus the bolt, should measure just under 18" if a carbine and just at 20" if a short rifle) I hope it still shoots OK for you.

Last edited by rightside; October 2, 2012 at 07:09 PM.
rightside is offline  
Old October 2, 2012, 08:08 PM   #12
couillon
Member
 
Join Date: August 3, 2012
Posts: 57
That's a Calvalry Carbine with the folding bayonet cut off. Looks like it has been inletted into an actual M1 Carbine stock. That is not the original Carcano wood.
couillon is offline  
Old October 2, 2012, 08:17 PM   #13
couillon
Member
 
Join Date: August 3, 2012
Posts: 57
looking again at the profile, it may actually be a potbelly M2 stock they used.
couillon is offline  
Old October 2, 2012, 08:20 PM   #14
donbjazzbones
Junior Member
 
Join Date: October 2, 2012
Posts: 13
update

well thanks for the info on the ammo now what to hunt with :P heres some more pics of the front site if it helps figure it out what it is ... and the length of the barrel i wasnt sure where u measure it from so i took some more






donbjazzbones is offline  
Old October 2, 2012, 08:24 PM   #15
couillon
Member
 
Join Date: August 3, 2012
Posts: 57
17 inches would be correct for the calvalry carbine. Google carcano calvalry carcano and look at some pictures. The front sight block is the same, but again has had the folding bayonet removed and the sight block rounded. You can see the grinding marks in your third picture. What would be cool is to remove it from the M1/M2 Carbine stock and put it in a repro folding paratrooper stock.
couillon is offline  
Old October 2, 2012, 08:29 PM   #16
donbjazzbones
Junior Member
 
Join Date: October 2, 2012
Posts: 13
looking it up it does seem to be the potbelly m2 stock .... this guy must have been to broke to buy an m1 so he made his own lmfao m2 stock m1 front end :P one of a kinda carcano hahahah
donbjazzbones is offline  
Old October 2, 2012, 08:38 PM   #17
donbjazzbones
Junior Member
 
Join Date: October 2, 2012
Posts: 13
oh like the old school m1 folding stock? now thats a good idea!

so looking at it all was $100 a good deal? i figure any rifles worth that even not knowing what it was at the time.

Last edited by donbjazzbones; October 2, 2012 at 08:50 PM.
donbjazzbones is offline  
Old October 2, 2012, 08:50 PM   #18
couillon
Member
 
Join Date: August 3, 2012
Posts: 57
No Italian Cartouche remnants on the stock by chance? Italy had M1 Carbines. If so, it could be an old Italian civilian conversion done before import.
couillon is offline  
Old October 2, 2012, 08:51 PM   #19
donbjazzbones
Junior Member
 
Join Date: October 2, 2012
Posts: 13
no there are no markings on the stock
donbjazzbones is offline  
Old October 3, 2012, 09:33 PM   #20
Craig010
Member
 
Join Date: September 2, 2012
Location: Sierra Vista, AZ
Posts: 30
I have three Carcano's in my collection now. First one I picked up was a 7.35 which is next to impossible to find ammo for these days. Here's a site you may find interesting. It answered a lot of my questions when I picked up my first one and has a lot of just interesting information to boot.

http://the-puzzle-palace.com/files/carcano.html

~Craig
Craig010 is offline  
Old October 8, 2012, 02:35 PM   #21
couillon
Member
 
Join Date: August 3, 2012
Posts: 57
I am on a different monitor today and can see the pictures lighter. I see the oiler slot in the stock. I am certain now it is a Carcano Calvary Carbine in a Potbelly M1 Carbine stock. With a M1 Carbine oiler you could use an M1 Carbine sling on it. Interesting combination. It is a shame ammo is so expensive for that one.
couillon is offline  
Old October 8, 2012, 05:21 PM   #22
donbjazzbones
Junior Member
 
Join Date: October 2, 2012
Posts: 13
27$ a box from hornady.... i shot it the other day the bolt is a little sticky but at 100 yards im shooting nice 1 inch groups surprisingly. Ive got a 30-30 and a 7mm with a scope ect but im determined to shoot a mulie with the carcano this week im headed out hunting wed!
donbjazzbones is offline  
Old October 12, 2012, 03:27 PM   #23
clamman
Junior Member
 
Join Date: May 19, 2010
Posts: 12
A own a 7.35 and took my first deer with it back around 1971 in northern Wisconsin.
clamman is offline  
Old October 12, 2012, 10:02 PM   #24
sc928porsche
Senior Member
 
Join Date: May 29, 2008
Location: now living in alabama
Posts: 2,433
Privi Partizan make ammo for it at a decent price. The clip is definately a must and are easy to lose so try to get a couple for spare. Old story on those is there once was an ad: Sale - WWII Italian rifles. Never fired and only dropped once.
__________________
No such thing as a stupid question. What is stupid is not asking it.
sc928porsche is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:41 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.11658 seconds with 9 queries