The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old September 13, 2012, 02:06 PM   #1
G. Freeman
Senior Member
 
Join Date: September 1, 2001
Location: Walnut, California
Posts: 153
Proper tool to measure 90 degrees for pins

Hi Guys,
Is there a good tool that I can measure or make sure that a pin is 90 degrees in relation to the rest of the part as in a 1911 thumb safety or slide stop?

I've tried using a straight edge or triangle but the area that joins the pin to the part is beveled & I coudn't get an accurate measure. Most of these rulers have a very sharp edge.

I know that I can just place the part into the gun, but sometimes I'm lazy in having to disassemble a gun to test fit a part. There are times I just like to keep some parts as spares without pulling apart my gun.

Thanks in advance!
G. Freeman is offline  
Old September 13, 2012, 03:35 PM   #2
HiBC
Senior Member
 
Join Date: November 13, 2006
Posts: 3,564
One way,if you have access to a lathe or a mill or an accurate drill press,would be to drill /ream a hole of the pin size in a piece of flat stock,or if in the lathe,just face the round stock and put in the hole

This is the basic idea of a functional gage.

A vee block may also tell you what you need to know.
HiBC is offline  
Old September 14, 2012, 09:45 AM   #3
Unclenick
Staff
 
Join Date: March 4, 2005
Location: Ohio
Posts: 10,206
Note that holes in gun frames aren't always perfectly perpendicular to the sides of the frame, either, so knowing the safety pin is perpendicular to the safety lever and base plate may or may not get you what you are looking for. I designed my own 1911 sear honing fixture long ago because of this. It lets me angle honing across the nose by half thousandths until I get even contact with the hammer hook and sear in a particular frame. No two seem to be exactly the same.
__________________
Gunsite Orange Hat Family Member
CMP Certified GSM Master Instructor
NRA Certified Rifle Instructor
NRA Benefactor Member
Unclenick is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:44 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06726 seconds with 9 queries