The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old August 30, 2012, 01:54 PM   #1
Senior Member
Join Date: August 27, 2012
Posts: 321
What is the extra "gizmo" in the Hornady die set?

Dies are Hornady 40S&W/10MM nitride 3-set dies. The three dies cam fully assembled.

However, there is a single stainless piece (1 3/8 tall) included in the plastic box that has a flat bottom and a lip at the top. It looks like a seating stem without a hollow area for the bullet nose.

This is my first set of Hornady dies. Is this a seating stem for a wad cutter (flat nose) bullet?

I don't see anything on point in the instruction booklet that came with the die set. The instructions seem to be generic for all pistol/rifle die sets.

rajbcpa is offline  
Old August 30, 2012, 03:25 PM   #2
Senior Member
Join Date: November 9, 2005
Location: Ohio, Appalachia's foothills.
Posts: 3,779
It is a flat seating plug for use on flat nose bullets, like XTP bullets.

sudo passwd root
mrawesome22 is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 07:09 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2015 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.10687 seconds with 9 queries