The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old June 5, 2012, 07:56 PM   #1
billybob1
Junior Member
 
Join Date: June 5, 2012
Posts: 1
44 bisley

Has anyone tried re chambering a 44 magnum Bisley to 44 40 ?
billybob1 is offline  
Old June 5, 2012, 08:44 PM   #2
Wyosmith
Senior Member
 
Join Date: December 29, 2010
Location: Shoshoni Wyoming
Posts: 1,161
It would not be hard to do, but I don't know why you'd want to.

The correct bullet diameter of a 44-40 is .427. A 44 mag is .429" and some run as large as .431". So you would not get good accuracy unless you used
.429"-.430" bullets.

You should also change the expander in the loading die to .001" under bullet size.

If you did that you should get very good accuracy, but no better than just loading the 44 mag down to 900 FPS with a 200-225 grain bullet, or using a 44 special at the same velocity and bullet weight.

Seems like a lot of work to do for nothing in return to me, but hey.......that's just my opinion.
Wyosmith is offline  
Old June 5, 2012, 09:23 PM   #3
Jim Watson
Senior Member
 
Join Date: October 25, 2001
Location: Alabama
Posts: 10,925
A .44-40 reamer will not "clean up" a .44 Magnum chamber.
The WCF is faintly bottlenecked and larger near the base, but the thin brass and smaller nominal bullet make it smaller in the neck. It would work after a fashion but I would not expect great accuracy and brass life would be short.

There was a guy who rechambered Herters .401 Power Mag to .38-40 with a similar situation. He said it would not affect the shooting, but then he was advertising a service.
Jim Watson is offline  
Old June 5, 2012, 10:36 PM   #4
HiBC
Senior Member
 
Join Date: November 13, 2006
Posts: 3,525
This thought had crossed my mind,but,for me,I do not think I will pursue it.

As I understand how it all works,the 38-40 and 44-40 ,with the thin brass and shallow bottleneck,could feed up into a lever action chamber well,and the brass obturated very well to keep the black powder fouling forward of the case mouth.

What I was wondering about: Necking down modern,strong 45 Colt brass to feed a .44 magnum barrel.Rim size is pretty much the same.So,this would be a hot rodding effort.

In theory,some case capacity could be gained,and turning the corner into a lever gun chamber would be easier.Mag tube would be the same.

On balance,a straight sided pistol case is real easy to work with.Ideas!!Get a lot of them,life and money are too short to chase them all!!This one did not make my list.
HiBC is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:44 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06428 seconds with 9 queries