The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old May 10, 2012, 08:44 AM   #26
serf 'rett
Senior Member
 
Join Date: June 25, 2009
Location: Stuttgart
Posts: 1,389
Some food for thought. If the full charge of powder fails to drop into one case, due to bridging, then the next case may get a double charge. Worst case scenario would be for the two rounds being loading in sequence and then shot during rapid fire. First round lodges a bullet in the barrel, then the double charged round is fired next….
__________________
A lack of planning on your part does not necessarily constitute an emergency on my part.
serf 'rett is offline  
Old May 10, 2012, 05:18 PM   #27
dunerjeff
Senior Member
 
Join Date: March 31, 2011
Location: central Wisconsin
Posts: 440
I load a majority on a proggresive, with a check die,and I still look into all cases as I place a bullet.That is just something that should be done.

As to the OP, it does sound like you are starting at too low a charge(as you stated "I couldn't tell between [B]1.7gr[B] and 7gr). Your 1.7gr comment make me think that is what your using as a start load??.

Anyway, when you look at your manual, it will state STARTING load 3.7(just an example) and a max load 4.9. You should be starting at 3.7, not "12% below starting load", which is what I believe you said in one of your posts. I would relook at your charge and what the manual says. Therein lies the issue? yes?? maybe???

Most powders, if not enough(1-2gr) is put in the case(depending on volume) won't "ignite explosively" just smolder,flash, and smoke,(put a spot on the sidewalk and light it,you'll see what I mean.That would mean the primer is all the pressure you'll get to push the bullet. Ironically ,a primer will push a bullet about 1/2" down the barrel, hmmmmmmmm
__________________
sent via telegram

Last edited by dunerjeff; May 10, 2012 at 05:25 PM.
dunerjeff is offline  
Reply

Tags
ftf , lee pro 1000 , misfire

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:01 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06477 seconds with 9 queries