|
May 4, 2012, 10:02 AM
|
#1 |
|
Member
Join Date: March 12, 2012
Posts: 26
|
CZ 82 slide problem
I just bought a CZ 82, the slide locks back with each shot and you have to thumb the release to load another round. Anyone have an idea? Thanks , wiggler
|
|
|
May 4, 2012, 10:12 AM
|
#2 |
|
Senior Member
Join Date: December 5, 2010
Location: Miami, Florida
Posts: 4,088
|
I have one..never had that issue. Try the lowest priced possible fix. Clean it very well. Second, if that fails. Buy a new magazine.
__________________
Sáncte Míchael Archángele, defénde nos in proélio, cóntra nequítiam et insídias diáboli ésto præsídium. Ímperet ílli Déus, súpplices deprecámur: tuque, prínceps milítiæ cæléstis, Sátanam aliósque spíritus malígnos, qui ad perditiónem animárum pervagántur in múndo, divína virtúte, in inférnum detrúde. Ámen |
|
|
|
May 4, 2012, 11:28 AM
|
#3 |
|
Senior Member
Join Date: June 2, 2006
Location: N. Virginia
Posts: 3,604
|
The tiny L shaped spring, that holds down the slide release to keep it from "jumping" up during each round, has probably fallen out. This is a common flaw in the CZ82. Do a search for a tutoral on replacing it. Good luck.
See part #42, (not the same as a CZ83 spring) http://myweb.cableone.net/leolani/cz...sassembly.html Last edited by PSP; May 4, 2012 at 11:37 AM. |
|
|
|
May 4, 2012, 12:59 PM
|
#4 |
|
Junior member
Join Date: January 26, 2012
Posts: 1,066
|
Single load it and remove the magazine and shoot it. If it locks open without a mag, see the advice on the spring above. If it only does it with mags installed, then look to those as the problem.
Willie . |
|
|
|
May 4, 2012, 08:11 PM
|
#5 |
|
Member
Join Date: March 12, 2012
Posts: 26
|
I thank you for your anwsers, will check it out. If anyone else has a suggestion please comment. thanks, wiggler
|
|
|
 |
| Thread Tools | |
|
|
