The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old March 27, 2012, 05:01 PM   #1
EricBella
Member
 
Join Date: February 29, 2012
Posts: 21
Black Powder reloading

Does anyone have blackpowder reloading data for 45 long colt, 255 gr round? and 160 gr round for 38 spl?
EricBella is offline  
Old March 27, 2012, 05:42 PM   #2
twobit
Senior Member
 
Join Date: February 25, 2010
Location: Coyote Creak, SW Texas
Posts: 576
from the hodgdon web sight

Pyrodex In Cartridges: The mechanics of reloading metallic cartridges are quite simple, but there is one requirement of the modern shooter that cannot be overlooked. The modern loader must set aside his knowledge of loading with smokeless powders and embrace the ways of years gone by. It must always be remembered that blackpowder and Pyrodex are very inefficient powders by today's standards. The methods described here are consistent with good loading practices for Pyrodex and should be followed without regard to smokeless loading practices.

Pyrodex works best in straight walled cases, but it will work satisfactorily in bottle necked cartridges as long as our warnings are observed.

WARNING: Never allow an air space in any cartridge loaded with Pyrodex. The loading density must be 100% by light compression. 100% loading density may be accomplished in two ways:

The case is filled with powder to a level that will provide light compression of the powder (1/16" to 1/8") when the bullet is seated. Bottle necked cases must be loaded in this manner.

In straight walled cases, filler wads may be used to reduce the powder charge. This is done by inserting card or Polyethylene wads between the base of the bullet and the powder. Wads should be sized to the internal diameter of the cartridge case. The loader must be careful to insure that there are no void spaces in the assembled cartridge. NEVER use any other type of filler material. Be careful as loads are reduced. At some point, the bullet will fail to exit the bore.

When loading cartridges with Pyrodex or Triple Seven, you may use a powder measure designed for smokeless powders. Learn more.

Pyrodex does produce a corrosive residue from combustion. Even though this fouling is softer than the fouling produced by blackpowder, firearms should be cleaned after each use. Hodgdon Powder Co. recommends the use of natural cleaning solvents.

Cartridge cases that have been fired using Pyrodex require special care. As soon as possible after firing, cases should be de-primed and immersed in 50% water and white vinegar. The acidity of the vinegar will neutralize the corrosive residues remaining in the case. Care should be taken to limit the soaking time of the cases in the vinegar to 10 minutes. Soaking for a longer time may cause etching of the brass case resulting in shortened case life. Rinse cases with clear water, dry and polish in a tumbler with corncob or walnut shell media.
__________________
Twobit,
Strive to live up to the opinion that your dog has of you.
twobit is offline  
Old March 27, 2012, 10:32 PM   #3
tom234
Senior Member
 
Join Date: February 14, 2008
Location: Kansas
Posts: 752
Pryodex isn't' black powder..........
I'd think you'll find more info posting in the "Black Powder and Cowboy Action Shooting" forum.
tom234 is offline  
Old March 28, 2012, 03:53 PM   #4
twobit
Senior Member
 
Join Date: February 25, 2010
Location: Coyote Creak, SW Texas
Posts: 576
Agreed, but it is a black powder substitute and loads the same. Also a lot easier to get than real black powder. Many store no longer carry real black powder. Too many hoops for them to jump through with ATF.
__________________
Twobit,
Strive to live up to the opinion that your dog has of you.
twobit is offline  
Old March 29, 2012, 08:18 AM   #5
Rifleman1776
Senior Member
 
Join Date: April 25, 2010
Location: Arkansas
Posts: 3,309
He asked about black powder and the long respone was about something else. Short answere, black powder being low pressure, just fill case, seat bullet. Shoot.
Rifleman1776 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:57 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07127 seconds with 9 queries