The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old February 16, 2012, 11:35 AM   #1
walleye
Junior Member
 
Join Date: February 15, 2011
Posts: 6
.223 o.a.l.

Unfortunately, my .223 rifle is not where I am reloading, but have been loading 45, 50, and 55 grain bullets using Lyman reloading manual for data. However, I see the o.a.l. for suggested loads to be different than the recommended o.a.l. from Hodgson. specifically. For example, Lyman says o.a.l. should be 2.260 in., while Hodgson says o.a.l. length should be 2.220". This is with a 55 gr. sp bullets. It just seems like the bullet sticks out a long ways at 2.260". Again when the bullet has cannelure that cannelure appears quite a distance from the case. I believe that commercial ammo o.a.l. is about 2.226, if I remember correctly. I am concerned about pressure, as most would be. Performance is important but only after safe pressure is obtained. Maybe seem like a ridiculous concern. If I had the rifle with me now I could adjust length, maybe. Appreciate any imput. I just wish I had the rifle with me now so I could try it. I don't, so have to do next best thing! Another ?: does the kind of bullet have an important impact on the pressure,e.g., sp vs hollow point vs. nosler s.p. . Using a Rem. 700 BDL rifle.

Last edited by walleye; February 16, 2012 at 11:46 AM.
walleye is offline  
Old February 16, 2012, 01:38 PM   #2
Zach W.
Member
 
Join Date: March 4, 2010
Posts: 69
Use an oal that works for your situation.

For a bolt gun, you want to get the bullet close to the rifling.

For an auto loader, magazine length will typically limit how far out you can seat the bullet.
Zach W. is offline  
Old February 16, 2012, 04:59 PM   #3
PA-Joe
Senior Member
 
Join Date: June 9, 2010
Location: NEPA
Posts: 719
The shape of each bullet maker's bullets is very different and therefore will have a much different COL. You cannot interchange the data. If you check the Lyman's manual it should tell you who's bullet they were using. Also remember to have reliable feeding your your magazine may limit your COL.
PA-Joe is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:06 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05995 seconds with 9 queries