The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old January 31, 2012, 12:22 AM   #26
dunerjeff
Senior Member
 
Join Date: March 31, 2011
Location: central Wisconsin
Posts: 440
When I set rifle oal,I take a fired round an just so bump it with the sizer die so it holds the bullet I'm using,but still allows the bullet to slide in.I seat the bullet long and then carefully chamber the dummy round so as the bullet hits the lands,it is pushed into the case.When you take the round out of the gun,carefully so it doesn't hit or bump anything,I them measure coal with my comparator.That is the max coal that will fit in your chamber.Now set your seater die .02 shorter,you are now .02 off the lands.
As long as that length fits in your mag,your good to go with your normal load work up. I don't even look at the book coal. It is almost meaningless to me.That is just what THEY loaded to and what fit in their rifle.
__________________
sent via telegram
dunerjeff is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:18 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05359 seconds with 9 queries