The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old December 27, 2011, 07:38 PM   #1
Lilswede1
Senior Member
 
Join Date: September 8, 2008
Location: NW Wash State
Posts: 181
Ultra Sonic Cleaner

Looking for a good receipe for pretty dirt brass.
Lilswede1 is offline  
Old December 27, 2011, 09:16 PM   #2
wncchester
Senior Member
 
Join Date: December 1, 2002
Posts: 2,832
Soap and water.
wncchester is offline  
Old December 28, 2011, 05:34 AM   #3
toolguy2006
Senior Member
 
Join Date: December 28, 2010
Location: Western Washington State
Posts: 144
This works great for me.

http://www.6mmbr.com/ultrasonic.html
toolguy2006 is offline  
Old December 29, 2011, 02:13 AM   #4
CMD-Ky
Member
 
Join Date: November 6, 2011
Posts: 18
One teaspoon citric acid crystals to one quart of water. Use the heater and cycle once to purge air from the solution. Then dump the cases, let the solution get hot with the cartridges and cycle again. Clean primer pockets, clean case - inside and out.
CMD-Ky is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:22 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06174 seconds with 9 queries