The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old December 6, 2011, 01:23 AM   #1
notamo
Junior Member
 
Join Date: December 6, 2011
Posts: 1
Trouble re-assembling Beretta Model 34

We have had a Beretta Model 34, made sometime between 1967 and 1973, sittting untouched for a long time. I thought it might be good to clean it, so I googled how to field strip it. After locking the slide back I had to tap the barrel back with a rubber mallet to dis-assemble. Now I can't get the barrel back in. Is it normal to have to use much force? One site I found said to put the barrel in place then release the slide a few times. Could this do any harm?
This pistol has not been shot (or even touched) for at least 20 years, and judging from the looks it has seen extremely little use. If it is not obvious by now, I am a newbie to guns.
Thanks for any suggestions.
notamo is offline  
Old December 6, 2011, 03:05 PM   #2
john323
Member
 
Join Date: June 16, 2009
Location: MONTEREY PARK , CA
Posts: 74
P/M sent.
__________________
johnsgunsmithing@live.com

Southern California
Anything legal, Rifles, Handguns, Shotguns, Black powder
john323 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:46 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06092 seconds with 9 queries