The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old December 1, 2011, 05:18 PM   #1
tal
Junior Member
 
Join Date: November 24, 2011
Posts: 8
Lathe Verses Case Trimmer

I am Totally new to Reloading and just recently Purchased a reloading press Kit.
It did not include a case trimmer. But I do Have a small Taig Lathe.
Does anyone here prepare there Brass cases on a lathe instead of a trimmer?
If so what cutter heads, Uniformers, and all the other attachements would you get to be able to prepare the cases on a lathe?
Primarily starting out with 223 rem for single shot break open rifle.
tal is offline  
Old December 2, 2011, 12:28 PM   #2
edward5759
Senior Member
 
Join Date: September 15, 2009
Location: Phoenix, AZ. 30 miles from water, two feet from Hell.
Posts: 354
E- mail me for some of my pictures.

I use nothing but a lathe for brass prep.

Small bench top or the type Enco sells are great and have a lot of uses.

Edward5759
__________________
Failure is part of success!

This year will go down in history. For the first time, a civilized nation has full gun registration. Our streets will be safer, our police more efficient, and the world will follow our lead into the future!" -Adolf Hitler,1935"
edward5759 is offline  
Old December 2, 2011, 04:56 PM   #3
tal
Junior Member
 
Join Date: November 24, 2011
Posts: 8
I can't find your address in the info. If you would like just send the photos to momega@atmc.net
Thanks
tal is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:10 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06175 seconds with 9 queries