The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old October 10, 2011, 08:05 AM   #1
AMT8951
Senior Member
 
Join Date: June 7, 2005
Location: Central NY
Posts: 492
Colt Det Spl Mainspring.

How hard is it to change out the Mainspring in an older model Colt Det Spl? Is it something I can do at home, or best left to a pro? Thanks
__________________
.40 cal Sig 2340
Kahr E9
S&W M65-5
RIA Midsize .45acp
Glock 21
Olympic Arms M4
Win M70 .375 H&H
FN PBR .308
Win M69A .22
Mini-14
Ithica M37 Deerslayer 12ga
Remington 721 30/06
AMT8951 is offline  
Old October 10, 2011, 11:20 AM   #2
Scorch
Senior Member
 
Join Date: February 13, 2006
Location: Washington state
Posts: 11,507
Not hard to do if you know how. But then you can say that about lots of things.

1- Take the grips off
2- Remove the 3 screws holding the side plate on
3- Hold the cylinder latch to the rear slightly
4- Tap the grip frame gently with the handle of the screwdriver, the sideplate will lift itself off
5- Compress the mainspring, unhook from the hammer stirrup, remove
6- Install the new spring into the frame, hook tip onto hammer stirrup
7- Make sure the hand is pressed in and fits within the hand window
8- Replace the sideplate gently, press it into place. DO NOT hit it or force it!! Make sure the latch piece fits over the latch pin and the hand stays in place
9- Replace the screws. If everything is in the right places, test the action. If it works, replace the grips. If not, remove the sideplate and get the hand and latch in place and try again.

Once you've done a few dozen, they're easy!! Just like brain surgery!

If all this is intimidating, consult a pro (good luck finding anyone who works on old Colts anymore).
__________________
Never try to educate someone who resists knowledge at all costs.
But what do I know?
Summit Arms Services
Taylor Machine
Scorch is offline  
Old October 10, 2011, 11:57 AM   #3
James K
Staff
 
Join Date: March 17, 1999
Posts: 19,847
Actually, you can replace those old Colt mainsprings without removing the sideplate at all, using a special clamp or padded needle nose pliers. Saves a lot of time and eliminates screw and sideplate problems. (Same with S&W mainsprings, both the flat and coil type.)

Jim
__________________
Jim K
James K is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:28 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06668 seconds with 9 queries